Editor’s note: Our Mind Upon Mind series is a nod to a 1937 Chips from the Chisel column (also featured in “Honest Labour: The Charles H. Hayward Years”), in which Hayward wrote, “The influence of mind upon mind is extraordinary.” The idea being there’s often room for improvement. To that end, we’ve asked you what else you have thought of, tried out and improved upon after building projects from our books.
Send us your own ideas! Email [email protected]. You can read more about the submission process here.
Listen beautiful relax classics on our Youtube channel.
Today’s pick is courtesy of Shawn Graham, of Albino Deer Woodworks. Thanks, Shawn!
— Kara Gebhart Uhl
In issue 3 of The Stick Chair Journal and on the Never Sponsored Substack, Chris gives a review of and instructions for using the Stanley No. 77 Doweling Machine for creating the round tenons on long and short sticks.
He recommends using the “stock guide plate,” and shares his method for holding the stick and feeding slowly while cranking fast.
I had already been experimenting with the No. 77 for this, but even following these great instructions, including using the Woodka and a spoke pointer to cone the end, I could not get a great, centered cut.
My solution: I had a cheap machinist cross-slide vise lying around for the drill press and decided to bolt it in front of my dowel machine. I can now clamp the stick with no wobble or vibration (I use shims to set the stick height on the vise). I can center the stick perfectly and feed it at a very consistent rate with the vise crank while turning the doweling machine crank at a consistent rate. Additionally, I can stop perfectly on the scribed line for the length.
With so many sticks to do, this method allows me to sit in a comfortable position and also lets me see the work more closely. It works amazingly well, and my tenons are really nice (the ones in the photo are in cherry).
— Shawn Graham, Albino Deer Woodworks
Source: lostartpress.com